![]() Your not trying to test this port forward from a device on your 192.168.1 network are you? That would be a nat reflection and whole different ball of wax to why it might not be working.Ī quick glance at your forward and your rules look ok - so my take would be upstream either your isp, your router or where your testing from is blocking 3389? Its not a very good idea to open 3389 to the public internet btw. Is the the service actually running and listening.Īll of these troubleshooting steps are gone over in the doc you listed. Windows out of the box sure and the hell not going to allow for rdp from some public IP address. If so and you get no response then problem on client - firewall on client. Sniff on lan - does pfsense send it on to the IP you want to send it too, ie this 192.168.1.55 address. If you validate traffic is getting to you - and still not working. ![]() canyouseeme org is good site for testing this. Simple packet capture while you try and access that port from remote. To be honest first step in troubleshooting is validating that traffic actually gets to pfsense WAN. Let me know if I need to provide anything else. Any assistance would surely be appreciated and thanks in advance. Like I said this was not an issue when I had my first router in bridge mode, just when we switched to Uverse fiber after relocating. I am able to get out to the world and ping out but I can not get the external to internal port checks to work either. I am wondering if something is either incorrect with the gateway or with the NATTing. I have placed the PFsense router in IP Passthrough in the NVG firewall to allow all traffic to my pfsense box. It was not a problem when I had my spectrum router and was able to put it into bridge mode the simple way, but ATT F**ks that up for you.Īrris NVG599 router(SUbnet changed to 192.168.2.254)-> PFSENSE Router I wanted to start off by just adding a simple RDP(3389) before adding any other ports for forwarding to allow external access to a desktop from my work location, but I can not for the life of me get this port forwarding to work. I am new to the whole PFsense thing in regards to running the system behind a POS Att Uverse fiber gateway, but any way i am stumped in the sense for port forwarding some ports. I know its probably something simple, at least I hope it is. ![]() I made sure to check the information below first before posting: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |